This Mississauga townhouse still had an old Stab-Lok panel. We replaced it with a brand-new Siemens panel, then filled in the directory and labelled it before we left. Here’s the swap in under half a minute.
The job
Stab-Lok is a line of panels and breakers made by Federal Pioneer and installed in Canadian homes for decades. You still find them in older homes across the GTA. This one was the townhouse’s original panel, and it was time for a new one.
What we did, step by step
- The old panel. We started with the old Stab-Lok panel, still in service.
- Power off at the meter. The meter outside was pulled, so the panel could be changed with the power completely off.
- The new Siemens panel. The new panel went in, and every circuit was connected to it on new breakers.
- Cover on, directory filled in. With the cover on, we filled in the panel directory, so every breaker says what it controls.
- Labelled. Our label went on the panel, so the homeowner knows who did the work and how to reach us.
Why the directory matters
A filled-in directory looks like a small detail until something trips. Instead of flipping breakers until the lights come back, the homeowner, or the next electrician, can go straight to the right one. We filled this one in before we left.
Should you replace a Stab-Lok panel?
Not every old panel has to come out today, but a panel that’s been in the wall for decades deserves a close look from a licensed electrician. These are the reasons we most often replace one:
- It’s the original panel and nobody has looked inside it in years.
- There’s no room left for new circuits.
- You’re adding a big load, like an EV charger, a heat pump or a basement unit. A load calculation tells you whether your service can carry it; our post on 100 amp vs 200 amp panels explains how we make that call.
- A home inspection flagged it before a sale or a renovation.
- Breakers trip for no clear reason, or you see signs of heat, like discoloured breakers or a warm cover.
In Ontario, replacing a panel needs an ESA permit, and the power is turned off at the meter while the panel is changed. We take care of the permit. Our panel and service upgrades page covers the work in more detail.
FAQ
Stab-Lok is a line of electrical panels and breakers made by Federal Pioneer and installed in many Canadian homes decades ago. You can usually spot one by the name on the panel door or the “Stab-Lok” strip on the breakers.
Most panel swaps take a day, with the power off for part of it. We’ll give you the timing when we look at your panel.
Yes. This job was in Mississauga, and we work across Toronto and the GTA. See our page for electricians in Mississauga.
Thinking about replacing your panel?
Murtex Electric Inc. is a licensed electrical contractor (ESA/ECRA licence 7016854) led by a licensed Master Electrician who has 13+ years of total experience in the electrical trade. We take care of ESA permits where required, across Toronto and the GTA.
Call or text (647) 529-2972, or request a quote online.
